Introduction


Some equipment have one or more measurements. Example : oxygen concentrator have different measures points : numbers of hours, % oxygen, flow at 5l/min... 

Some measure points are to information the use (number of hours, kilometers) and some others measures point are an performance indicator of the equipment. A limit can be defined by the technical referent (low limit and/or high limit). 


Example with oxygen concentrator : 

numbers of hours of the concentrator : information about the use

% oxygen : performance indicator. Limit : need to be more than 90%. 


If the measure is out of limit, the measurement point would appear in red in the WO in the laptop, and would appear with a green tick (check mark) 



To extract the last measurement for the same type measure point for all EQ


  • Open the application “METER” in the module MAINTENANCE.
  • Realise the filters needed to see only the measure point you want. In "description" by the name of the measure point and a filter in "num" with the MSF number or in "Equipment" with a keyword like brand or model. You can do a filter with the status to extract only the active EQ. You can also use the criteria filter to filter by type.

  • Click to the excel icon at the top right of the table.




To extract all measurements for one equipment 



  • Open the app EQUIPMENT 
  • Go to the tab Measure point 
  • Click to the excel icon at the top right of the table.



To extract all measurements for all equipment


  • Contact the memo support for this request.